Gamma 5800 Els STRINGING MACHINE 2 POINT SC MOUNTING (Is Uživatelský manuál stáhnout pdf (Strana 5)

Base Leg Assembly

The stringing machine uses a four leg base

design. The legs must be assembled to the

support post before use. Remove the lower

column support, the upper column support,

four (4) legs, four (4) socket head cap

screws and four (4) flat head cap screws

from the small shipping carton.

Base Leg Assembly (Cont.)

Align the holes in the leg flange with the

matching holes in the lower column support

post. Secure the leg with one flat head cap

screw through the upper hole, and one socket

head cap screw through the bottom hole.

Repeat this procedure for the three remain-

ing legs.

ASSEMBLY INSTRUCTIONS

Base Leg Assembly (Cont.)

To complete the base stand, screw the height adjust-

ment locking knob (“A”) into the side of the support

column. The locking knob should not protrude beyond

the inside of the support column at this time.

“A”

1 2 3 4 5 6 7 8 9 10 ... 23 24

Žádné komentáře

Gamma 5800 Els STRINGING MACHINE 2 POINT SC MOUNTING (Is Uživatelský manuál Strana 5